Automatic Garage Door Closes Then Opens

Garage door opener keeps going back up.

Automatic garage door closes then opens.

You push the button to close the garage door. How to fix a garage door that keeps reversing. It may be your garage door sensor. If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.

As these wires short against the housing the electrical impulse causes the door opener to activate. The garage door goes down then back up. In the down direction if the limit is set beyond the point at which the door closes fully the door will hit the floor and act as if it is hitting something and the safety feature tells it to reverse. Close the garage door with the opener and watch it closely as it closes.

The symptom of this is a garage door that is in constant motion opening fully then immediately descending only to start the same cycle again. Your garage door opens when it hits the ground. Your garage door s logic board is the brain of your garage door opener. If you re craftsman chamberlain etc garage door opener is closing and then opening up its likely a common problem related to the stop limit mechanism.

Think of a garage door s travel limit as the distance it needs to travel to close or open entirely. In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor. If the garage door does not close completely or begins to close and then opens back up again the down limit switch needs. When the logic board wears out it can cause your garage door to close then open and vice versa without explanation.

By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. There are four common problems with garage door sensors three of these homeowners can fix. Your garage door opens immediately after closing. It goes partway down reverses direction and goes back up again.

This is almost always the result of a. There may also be loose wire connections inside the button housing itself. You have an open limit and a close limit on your garage door opener. If your garage door fully closes touches the floor and then reverses back up then you need to decrease the travel limit.

The garage door keeps going up and down. Get logic board replacement.